Kia Optima: RCCW (Rear Cross-Traffic Collision Warning) / Operating conditions To operate
• Go to “User Settings → Driving Assist and select Rear Cross Traffic Collision
Warning” on the LCD display.
The system will turn on and standby to activate. If you deactivate this function
in the cluster, the system will stop.
❈For more information, refer to “LCD Display” in chapter 4.
✽ NOTICE
- If the vehicle is turned off and on again, the RCCW system will return
to the state right before the vehicle was turned off.
- The system will activate when vehicle speed is below 10 km/h (6.2 mph)
and with the shift lever in R (Reverse).
- The Rear Cross-Traffic Collision Warning (RCCW) detecting range is approximately
0.5 m ~ 20 m (1 ft ~ 65 ft) in the direction of both lateral sides of the car.
An approaching vehicle will be detected if their vehicle speed is within 4 km/h
~ 36 km/h (2.5 ~ 22.5 mph).
Note that the detecting range may vary under certain conditions. As always,
use caution and pay close attention to your surroundings when backing up your
vehicle.
The Rear Cross-Traffic Collision Warning function monitors approaching cross
traffic from the left and right side of the vehicle when your vehicle is in reverse. ...
If the vehicle detected by the sensors approaches your vehicle, the warning chime
will sound, the warning light on the outside rearview mirror will blink and a message
will appear on the LCD ...
Other information:
When using a floor mat on the front floor carpet, make sure it attaches to the
floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward.
WARNING - After market floor mat
Do not install aftermarket floor mats that are not capable of being securely
attached to the veh ...
Components and components location
Components
1. Transaxle Support Braket
5. Roll Rod Support Bracket
2. Driveshaft Assembly [RH]
6. Sub Frame
3. Driveshaft Assembly [LH]
7. Driveshaft Heat Protector
...