Kia Optima DL3: Tires/Wheels / Wheel
Repair procedures
| Removal |
| 1. |
Remove the wheel and tire (A). [Front]
[Rear]
|
| Installation |
| 1. |
Install the wheel and tire (A). [Front]
[Rear]
|
Hub Nut Tightening Sequence
| 1. |
Tighten the hub nuts as follows.
|
Run out inspection
| 1. |
Jack up the vehicle. |
| 2. |
Measure the wheel Run-out by using a dial indicator as illustration below.
|
| 3. |
If measured value exceeds the standard value, replace the wheel.
|
Repair procedures Tire Wear • Using tires and wheels other than the recommended sizes can cause unusual handling characteristics and poor vehicle control, resulting in a serious accident.
Repair procedures Front Wheel Alignment • When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle on a level surface with the front wheels facing straight ahead.
Other information:
Kia Optima DL3 2019-2026 Service and Repair Manual: Ambient Temperature Sensor
Description and operation Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature.
Kia Optima DL3 2019-2026 Service and Repair Manual: Blower Motor
Repair procedures Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.
Categories
- Manuals Home
- Kia Optima Owners Manual
- Kia Optima Service Manual
- Engine Mechanical System
- Timing Chain
- Instrument panel overview
- New on site
- Most important about car
