Kia Optima: Crash Pad / Glove Box

Kia Optima DL3 2019-2020 Service and Repair Manual / Body (Interior and Exterior) / Crash Pad / Glove Box

Components and components location
Component Location

1. Glove box


Repair procedures
Replacement
  

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Take care not to bend or scratch the trim and panels.

Put on gloves to prevent hand injuries.

1.

Open the glove box (A) in the direction of the arrow.

2.

Separate the air damper (A) from the glove box.

3.

Press both sides inwards to open the glove box (A) downwards.

4.

Remove the glove box (A).

5.

To install, reverse removal procedure.

Crash Pad Garnish
Components and components location Component Location 1. Crash pad garnish [LH] 2. Crash pad garnish [RH] 3. Crash pad center garnish Repair pro ...

Crash Pad Side Cover
Repair procedures Replacement    • When removing with a flat-tip screwdriver or remover, wrap ...

Other information:

Kia Optima DL3 2019-2020 Service and Repair Manual: Rear Lower Arm


Repair procedures Removal 1. Disconnect the (-) battery terminal. 2. Remove the rear wheel and tire. (Refer to Tires/Wheels - "Wheel") 3. Loosen the bolt and nut (A) and then remove the rear lower arm from the ...

Kia Optima DL3 2019-2020 Owner's Manual: Engine compartment fuse replacement


1. Turn the ignition switch and all other switches off. 2. Remove the fuse panel cover by pressing the tab and pulling the cover up. 3. Check the removed fuse; replace it if it is blown. To remove or insert the fuse, use the fuse puller in the engine compartment fuse panel. 4. Push in a new f ...

Copyright © www.kioptima.com 2017-2020