
■ Type A

■ Type B

■ Type C
The drive mode may be selected according to the driver’s preference or road condition.
The mode changes whenever the DRIVE MODE button is pressed.

ECO mode (Active ECO)

Active ECO helps improve fuel efficiency by controlling certain engine and transaxle system operating parameters. Fuel efficiency depends on the driver's driving habit and road condition.
When Active ECO is activated:
The above situations are normal conditions when the Active Eco System is activated to improve fuel efficiency.
Limitation of Active ECO operation:
If the following conditions occur while Active ECO is operating, the system operation is limited even though there is no change in the ECO indicator.
SPORT mode

SPORT mode focuses on dynamic driving by automatically adjusting the steering wheel, engine and transaxle system.
✽ NOTICE
In Sport drive mode, the fuel efficiency may decrease.
Press the CRUISE button (the CRUISE indicator light in the instrument cluster will go off). Turn the ignition off. Both of these actions will cancel the cruise control operation.
The Blind-Spot Collision Warning (BCW) system uses radar sensors in the rear bumper to monitor and warn the driver of an approaching vehicle in the driver's blind spot area.
Description and operation Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actu
Repair procedures Inspection 1. Measure the resistance between the terminals. 2. measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) (1) Pin No 1.