Kia Optima DL3: Driving your vehicle
- Before driving
- Key positions
- Engine start/stop button
- Automatic transmission
- Brake system
- Parking brake – Foot type
- Anti-lock brake system (ABS)
- Electronic stability control (ESC)
- Vehicle stability management (VSM)
- Hill-start assist control (HAC)
- Good braking practices
- Forward Collision-avoidance Assist (FCA) system
- System setting and activation
- FCA warning message and system control
- Brake operation
- FCA sensor (Front View Camera)
- System malfunction
- Limitation of the system
- Cruise Control System
- To set cruise control speed
- To increase cruise control set speed
- To decrease the cruising speed
- To cancel cruise control, do one of the following
- To resume cruising speed at more than approximately 30 km/h (20 mph)
- To turn cruise control off, do one of the following
- Drive mode integrated control system
- Blind-spot Collision Warning (BCW)
- BCW (Blind-Spot Collision Warning) / LCA (Lane Change Assist)
- RCCW (Rear Cross-Traffic Collision Warning)
- Driver's Attention
- Lane Keeping Assist (LKA) system
- Driver Attention Warning (DAW)
- Economical operation
- Special driving conditions
- Rocking the vehicle
- Smooth cornering, Driving at night
- Driving in the rain
- Driving in flooded areas, Driving off-road
- Highway driving
- Winter driving
- Vehicle load limit
- Vehicle weight
✽ NOTICE If you install an after market HID head lamp, your vehicle’s audio and electronic device may malfunction. Antenna Glass antenna When the radio power switch is turned on while the ignition switch is in either the "ON" or "ACC" position, your car will receive both AM and FM broadcast signals through the antenna in the rear window glass.
Before entering vehicle Be sure that all windows, outside mirror(s), and outside lights are clean. Check the condition of the tires. Check under the vehicle for any sign of leaks.
Other information:
Kia Optima DL3 2019-2026 Service and Repair Manual: License Lamps
Repair procedures Removal 1. Disconnect the negative battery terminal. 2. Remove the lcense lamp (A) by pressing the hook. 3. Disconnect the lcense lamp connector (A).
Kia Optima DL3 2019-2026 Service and Repair Manual: Vanity Lamp
Repair procedures Removal When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. 1.
Categories
- Manuals Home
- Kia Optima Owners Manual
- Kia Optima Service Manual
- Battery
- Headlamps
- Thermostat
- New on site
- Most important about car
