Kia Optima DL3: Front Seat / Front Seat Inner Shield Cover

Components and components location

Component Location

1. Front seat inner shield cover


Repair procedures

Replacement
  

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

Take care not to bend or scratch the trim and panels.

Put on gloves to prevent hand injuries.

1.

Remove the front seat assembly.

(Refer to Front Seat - "Front Seat Assembly")

2.

Remove the protector (A), loosen the mounting screw and remove the front seat inner shield cover (B).

3.

To install, reverse the removal procedure.

    Components and components location Component Location 1. Front seat outer shield cover Repair procedures Replacement    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

    Components and components location Component Location 1. Front seat back cover Repair procedures Replacement    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

    Other information:

    Kia Optima DL3 2019-2026 Service and Repair Manual: Heater Core

    Repair procedures Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater - "Heater Unit") 3. Loosen the mounting screws and remove the heater core cover (A).

    Kia Optima DL3 2019-2026 Service and Repair Manual: Blower Resistor

    Repair procedures Inspection 1. Measure the resistance between the terminals. 2. measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) (1) Pin No 1.

    Categories

     
    Copyright © 2026 www.kioptima.com - 0.0231