Kia Optima DL3: Battery / Recharging the battery

Your vehicle has a maintenance-free, calcium-based battery.

  • If the battery becomes discharged in a short time (because, for example, the headlamps or interior lamps were left on while the vehicle was not in use), recharge it by slow charging (trickle) for 10 hours.
  • If the battery gradually discharges because of high electric load while the vehicle is being used, recharge it at 20-30A for two hours.

When recharging the battery, observe the following precautions:

  • The battery must be removed from the vehicle and placed in an area with good ventilation.
  • Do not allow cigarettes, sparks, or flame near the battery.
  • Watch the battery during charging, and stop or reduce the charging rate if the battery cells begin gassing (boiling) violently or if the temperature of the electrolyte of any cell exceeds 49°C (120°F).
  • Wear eye protection when checking the battery during charging.
  • Disconnect the battery charger in the following order.
    1. Turn off the battery charger main switch.
    2. Unhook the negative clamp from the negative battery terminal.
    3. Unhook the positive clamp from the positive battery terminal.
  • Before performing maintenance or recharging the battery, turn off all accessories and stop the engine.
  • The negative battery cable must be removed first and installed last when the battery is disconnected.

Reset items

Items should be reset after the battery has been discharged or the battery has been disconnected.

  • Auto up/down window (See chapter 4)
  • Sunroof (See chapter 4)
  • Trip computer (See chapter 4)
  • Climate control system (See chapter 4)
  • Driver position memory system (See chapter 3)
  • Audio (See chapter 4)

    For best battery service Keep the battery securely mounted. Keep the battery top clean and dry. Keep the terminals and connections clean, tight, and coated with petroleum jelly or terminal grease.

    Tire care For proper maintenance, safety, and maximum fuel economy, you must always maintain recommended tire inflation pressures and stay within the load limits and weight distribution recommended for your vehicle.

    Other information:

    Kia Optima DL3 2019-2025 Service and Repair Manual: Power Window Switch

    Schematic diagrams Connector and Terminal Function Power Window Main Switch Pin Function 1 B-CAN (Low) 2 B-CAN (High) 3 Ground (Assist safety) 4 Assist safety 5

    Kia Optima DL3 2019-2025 Service and Repair Manual: Smart Key

    Repair procedures Adjustment Smart Key Code Saving 1. Connect the VCI II in driver side crash pad lower panel, turn the power on KDS. 2. Select the vehicle model and then do "Smart key code saving".

    Categories

     
    Copyright © 2025 www.kioptima.com - 0.0268