Kia Optima: Theft-alarm system / Theft-alarm stage, Disarmed stage

Kia Optima DL3 2019-2021 Owner's Manual / Features of your vehicle / Theft-alarm system / Theft-alarm stage, Disarmed stage

Theft-alarm stage

The alarm will be activated if any of the following occurs while the system is armed.

The horn will sound and the hazard warning lights will blink continuously for approximately 27 seconds, and repeat the horn 3 times unless the system is disarmed. To turn off the system, unlock the doors with the ignition key or transmitter (or smart key).

Disarmed stage

The system will be disarmed when

• The doors (and trunk) are unlocked with the transmitter (or smart key) or the ignition key.

After depressing the unlock button, the hazard warning lights will blink and the chime will sound twice (in smart key) to indicate that the system is disarmed.

After depressing the unlock button, if any door (or trunk) is not opened within 30 seconds, the system will be rearmed.

✽ NOTICE

CAUTION - Adjusting alarm system

Do not change, alter or adjust the theft-alarm system because it could cause the theft-alarm system to malfunction and should only be serviced by an authorized Kia dealer.

✽ NOTICE

Malfunctions caused by improper alterations, adjustments or modifications to the theft-alarm system are not covered by your vehicle manufacturer warranty.

Armed stage
Park the vehicle and stop the engine. Arm the system as described below. 1. Remove the ignition key from the ignition switch and exit the vehicle. 2. Make sure that all doors (and trunk) and engine ...

Door locks
...

Other information:

Kia Optima DL3 2019-2021 Owner's Manual: Vehicle identification number (VIN)


■ Frame number The vehicle identification number (VIN) is the number used in registering your vehicle and in all legal matters pertaining to its ownership, etc. The number is punched on the front side wall of the engine room. ■ VIN label The VIN is also on a plate attached to the top o ...

Kia Optima DL3 2019-2021 Owner's Manual: Turn signals and lane change signals


The ignition switch must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A). The green arrow indicators on the instrument panel indicate which turn signal is operating. They will self-cancel after a turn is completed. If the indicator continues ...

Copyright © www.kioptima.com 2017-2021