Kia Optima DL3: Rear Seat / Rear Seat Cushion Cover

Kia Optima DL3 2019-2026 Service and Repair Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Cushion Cover

Components and components location

Component Location

1. Rear seat cushion cover


Repair procedures

Replacement
1.

Remove the rear seat assembly.

(Refer to Rear Seat - "Rear Seat Assembly")

2.

Loosen the mounting screws and remove the car seat fixing bracket (A).
3.

Remove the rear seat cushion cover hog-ring clips and remove the rear seat cushion cover (A).

  

Be careful not to deviate from the pads, insert wires, and aplix.

[Rear]

[Front]

4.

To install, reverse the removal procedure.

  
•

To prevent wrinkles, make sure that the cover (B) is stretched evenly before connecting the hog-ring clips (A).
•

Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).

    Components and components location Component Location 1. Rear seat back cover Repair procedures Replacement 1.

    Components and components location Components 1. Front seat belt retractor 2. Height adjust 3. Rear seat belt buckle [LH] 4.

    Other information:

    Kia Optima DL3 2019-2026 Service and Repair Manual: Smart Key Antenna

    Repair procedures Removal Interior Antenna 1 1. Disconnect the negative battery terminal. 2. Remove the surround view monitor (SVM) unit. (Refer to Advanced Driver Assistance System (ADAS) - "Surround View Monitor (SVM) Unit") 3.

    Kia Optima DL3 2019-2026 Service and Repair Manual: In-car Sensor

    Description and operation Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater co

    Categories

     
    Copyright © 2026 www.kioptima.com - 0.0229