The parking distance warningreverse may not operate properly when:
1. Moisture is frozen to the sensor. (It will operate normally once the moisture
clears.)
2. The sensor is covered with foreign matter, such as snow or water, or the sensor
cover is blocked. (It will operate normally when the material is removed or the
sensor is no longer blocked.)
3. Driving on uneven road surfaces (unpaved roads, gravel, bumps, gradient).
4. Objects generating excessive noise (vehicle horns, loud motorcycle engines, or
truck air brakes) are within range of the sensor.
5. Rain or water spray exists.
6. Wireless transmitters or mobile phones are within range of the sensor.
7. The sensor is covered with snow.
8. Trailer towing
The detecting range may decrease when:
1. The sensor is covered with foreign matter such as snow or water. (The sensing
range will return to normal when removed.)
2. Outside air temperature is extremely hot or cold.
The following objects may not be recognized by the sensor:
1. Sharp or slim objects such as ropes, chains or small poles.
2. Objects which tend to absorb the sensor frequency such as clothes, sound absorbent
material or snow.
3. Undetectable objects smaller than 1 m (40 in.) in height and narrower than 14
cm (6 in.) in diameter.
Operating condition This system will activate when the indicator on the parking distance warning-reverse OFF button is not illuminated. If you desire to deactivate the parking distance warningreverse, press the parking distance warning-reverse OFF button again.
The parking distance warningreverse may not sound consistently depending on the speed and shapes of the objects detected. The parking distance warningreverse may malfunction if the vehicle bumper height or sensor installation has been modified or damaged.
Schematic diagrams Connector and Terminal Function Pin Function 1 B-CAN (Low) 2 B-CAN (High) 3 Ground (Assist safety) 4 Assist safety 5 LIN (For IMS)
Components and components location Component Location 1. Walk-in switch Repair procedures Removal When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply prote