Kia Optima DL3: Floor Console / Rear Console Cover

Kia Optima DL3 2019-2026 Service and Repair Manual / Body (Interior and Exterior) / Floor Console / Rear Console Cover

Repair procedures

Replacement
  
•

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•

Take care not to bend or scratch the trim and panels.
•

Put on gloves to prevent hand injuries.
1.

Remove the floor console assembly.

(Refer to Floor Console - "Floor Console Assembly")

2.

Disconnect the connectors (A).
3.

Using a remover and remove the rear console cover (A).
4.

To install, reverse the removal procedure.

  

Replace any damaged clips (or pin-type retainers).

    Components and components location Component Location 1. Front console assembly Repair procedures Replacement [SBC Console]    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

    Repair procedures Replacement    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

    Other information:

    Kia Optima DL3 2019-2026 Service and Repair Manual: High Mounted Stop Lamp

    Repair procedures Removal 1. Disconnect the negative battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3. Disconnect the high mounted stop lamp connector (A).

    Kia Optima DL3 2019-2026 Service and Repair Manual: Heater Unit

    Components and components location Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Temperature control actuator [LH] 3. PTC Heater dummy 4.

    Categories

     
    Copyright © 2026 www.kioptima.com - 0.0203