| Component Location |

| 1. Rear package tray trim |
| Replacement |
Rear package tray trim
|
| 1. |
Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly") |
| 2. |
Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly") |
| 3. |
Remove the rear door pillar trim. (Refer to Interior Trim - "Rear Pillar Trim") |
| 4. |
Loosen the mounting bolts and remove the luggage partition center trim cover (A).
|
| 5. |
Loosen the mounting bolt, remove the rear seat betl lower anchor (A).
[LH]
[RH]
[Center]
|
| 6. |
Using a flat-tip screwdriver and remove rear package tray trim (A).
|
| 7. |
To install, reverse the removal procedure.
|
Components and components location Component Location [General type] 1. Luggage partition center trim 2. Rear package tray trim 3.
Components and components location Component Location 1. Luggage side trim Repair procedures Replacement • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Repair procedures Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (PAG) oil varies according to compressor model.
Components and components location Component Location 1. Blower unit assembly Components 1. Intake actuator 2. Cluster ionizer 3. Air filter 4. Blower motor assembly 5.