Kia Optima DL3: Cooling System / Reservoir Tank

Kia Optima DL3 2019-2026 Service and Repair Manual / Engine Mechanical System / Cooling System / Reservoir Tank

Repair procedures

Removal and Installation
1.

Remove the reservoir tank.

(1)

Disconnect the degassing hose (A).

(2)

Disconnect the reservoir tank water hose (B).

(3)

Remove the reservoir tank (C).

Tightening torque :

7.8 - 11.7 N•m (0.8 - 1.2 kgf•m, 5.7 - 8.6 lb•ft)

2.

Install in the reverse order of removal.

    Repair procedures Refilling And Bleeding    Never remove the reservoir tank cap when the engine is hot.

    Components and components location Components 1. Cooling fan 2. Cooling fan motor 3. Cooling fan shroud Specifications Specifications Item Specification Fan type PULLER Fan speed control Resisor Air flow rate (㎥/h) 1,950 - 8% min.

    Other information:

    Kia Optima DL3 2019-2026 Service and Repair Manual: Power Door Mirror Switch

    Schematic diagrams Connector and Terminal Function Pin Function 1 B-CAN (Low) 2 B-CAN (High) 3 Ground (Assist safety) 4 Assist safety 5 LIN (For IMS)

    Kia Optima DL3 2019-2026 Service and Repair Manual: Ambient Temperature Sensor

    Description and operation Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature.

    Categories

     
    Copyright © 2026 www.kioptima.com - 0.0209