Kia Optima DL3: Indicator Lights / Electronic Stability Control (ESC) Indicator Light
This indicator light illuminates:
- Once you set the ignition switch or Engine Start/Stop Button to the ON position.
- It illuminates for approximately 3 seconds and then goes off. - When there is a malfunction with the ESC system.
In this case, have your vehicle inspected by an authorized Kia dealer.
This indicator light blinks:
While the ESC is operating.
❈For more details, refer to “Electronic Stability Control (ESC)” in chapter 5.
Electronic Stability Control (ESC) OFF Indicator Light This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position.
Other information:
Kia Optima DL3 2019-2026 Service and Repair Manual: Receiver-Drier
Repair procedures Replacement 1. Remove the condenser. 2. Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.
Kia Optima DL3 2019-2026 Service and Repair Manual: Mode Control Actuator
Components and components location Components Location 1. Mode control actuator Description and operation Description The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C co
Categories
- Manuals Home
- Kia Optima Owners Manual
- Kia Optima Service Manual
- Automatic Transaxle System
- Body Electrical System
- Motor Driven Power Steering
- New on site
- Most important about car
