Kia Optima: Drive Belt System / Idler

Kia Optima DL3 2019-2020 Service and Repair Manual / Engine Mechanical System / Drive Belt System / Idler

Repair procedures
Removal and Installation
1.

Remove the drive belt.

(Refer to Drive Belt System - "Drive Belt")

2.

Remove the idler (A).

Tightening torque :

39.2 - 49.0 N•m (4.0 - 5.0 kgf•m, 28.9 - 36.2 lb•ft)

3.

Install in the reveres order of removal.

Drive Belt Tensioner
Components and components location Components 1. Drive belt tensioner Repair procedures Removal and Installation 1. Remove the d ...

Crankshaft Damper Pulley
Components and components location Components 1. Crankshaft damper pulley Repair procedures Removal and Installation 1. Remov ...

Other information:

Kia Optima DL3 2019-2020 Owner's Manual: Hood


Opening the hood 1. Pull the release lever to unlatch the hood. The hood should pop open slightly. Only open the hood with the vehicle on a flat surface, engine is turned off, shift lever placed in P (Park) position and setting the parking brake. 2. Go to the front of the vehicle, raise the ...

Kia Optima DL3 2019-2020 Service and Repair Manual: Side Impact Sensor (SIS)


Description and operation Description The Side Impact Sensor (SIS) system consists of two kinds of side impact sensor which are installed at each center of the front door module (left and right) and two rear sensors which are installed in the rear pillar (left and right). ...

Copyright © www.kioptima.com 2017-2020