Kia Optima DL3: Driver Attention Warning (DAW) / Resetting the system
- The last break time is set to 00:00 and the driver's attention level is set to 5 (very attentive) when the driver resets the Driver Attention Warning system.
- The driver attention warning system resets in the following situations.
- The engine is turned OFF.
- The driver unfastens the seat belt and then opens the driver’s door in stop.
- Stop lasting more than 10 minutes. - The driver attention warning system operates again, when the driver restarts driving.
System disabled
The Driver Attention Warning system enters the ready status and displays the 'Disabled' screen in the following situations.
- The camera sensor keeps failing to detect the lanes.
- Driving speed remains under 64 km/h (40 mph) or over 177 km/h (110 mph).
System setting The Driver Attention Warning system is set to be in the Normal position, when your vehicle is first delivered to you from the factory.
When the “Check System” warning message appears, the system is not working properly. In this case, take your vehicle to an authorized Kia dealer and have the system checked.
Other information:
Kia Optima DL3 2019-2025 Service and Repair Manual: Ventilated and Heated Seat
Schematic diagrams Connector and Terminal Function Pin Function Connector A Connector B 1 Driver heater ground (-) Driver blower speed (+) 2 Passenger heater ground (-) - 3
Kia Optima DL3 2019-2025 Service and Repair Manual: Blower Resistor
Repair procedures Inspection 1. Measure the resistance between the terminals. 2. measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) (1) Pin No 1.
Categories
- Manuals Home
- Kia Optima Owners Manual
- Kia Optima Service Manual
- Body (Interior and Exterior)
- Steering System
- Thermostat
- New on site
- Most important about car
