Kia Optima DL3: Cruise Control System / To decrease the cruising speed
Follow either of these procedures:
- Move the lever down (to SET-) and hold it. Your vehicle will gradually slow down. Release the lever at the speed you want to maintain.
- Move the lever down (to SET-) and release it immediately. The cruising speed will decrease by 2 km/h (1.0 mph) each time the lever is operated in this manner.
To temporarily accelerate with the cruise control on:
If you want to speed up temporarily when the cruise control is on, depress the accelerator pedal. Increased speed will not interfere with the cruise control operation or change the set speed.
To return to the set speed, take your foot off the accelerator.
Follow either of these procedures: Move the lever up (to RES+) and hold it. Your vehicle set speed will increase by 10 km/h (5 mph). Release the lever at the speed you want.
Depress the brake pedal. Shift into N (Neutral) with an Automatic transmission. Press the CANCEL switch. Decrease the vehicle speed lower than the memory speed by 20 km/h (12 mph).
Other information:
Kia Optima DL3 2019-2026 Service and Repair Manual: Evaporator Core
Repair procedures Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater - "Heater Unit") 3. Loosen the mounting screws, lock pin and remove the evaporator core cover (A).
Kia Optima DL3 2019-2026 Service and Repair Manual: Intake Actuator
Components and components location Components Location 1. Intake actuator Description and operation Description The intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit.
Categories
- Manuals Home
- Kia Optima Owners Manual
- Kia Optima Service Manual
- Rear Bumper Assembly
- Engine Control / Fuel System
- Automatic Transaxle System
- New on site
- Most important about car
