Kia Optima DL3: Indicator Lights / Turn Signal Indicator Light, High Beam Indicator Light
Turn Signal Indicator Light
This indicator light blinks:
• When you turn the turn signal light on.
If any of the following occurs, there may be a malfunction with the turn signal system. In this case, have your vehicle inspected by an authorized Kia dealer.
- The indicator light does not blink but illuminates.
- The indicator light blinks more rapidly.
- The indicator light does not illuminate at all.
High Beam Indicator Light
This indicator light illuminates:
- When the headlights are on and in the high beam position
- When the turn signal lever is pulled into the Flash-to-Pass position.
This indicator light illuminates for up to 30 seconds: • When the vehicle detects the appropriate smart key with immobilizer in your vehicle while the Engine Start/Stop Button is ACC or ON.
High beam assist indicator This warning light illuminates : When the high-Beam is on with the light switch in the AUTO light position. If your vehicle detects oncoming or preceding vehicles, the High beam assist system will switch the high beam to low beam automatically.
Other information:
Kia Optima DL3 2019-2026 Service and Repair Manual: Smart Key Diagnostic
Repair procedures Inspection 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS). The diagnostic system (KDS) provides the following information. (1) Self diagnosis : Checking failure and code number (DTC).
Kia Optima DL3 2019-2026 Service and Repair Manual: Blower Resistor
Repair procedures Inspection 1. Measure the resistance between the terminals. 2. measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) (1) Pin No 1.
Categories
- Manuals Home
- Kia Optima Owners Manual
- Kia Optima Service Manual
- Steering System
- Engine Control / Fuel System
- Motor Driven Power Steering
- New on site
- Most important about car
