Kia Optima: Airbag Module / Passenger Airbag (PAB) Module
Description and operation
The passenger airbag (PAB) is installed inside the crash pad and protects the
front passenger in the event of a frontal crash. The SRSCM determines if and when
to deploy the PAB.
• |
Never attempt to measure the circuit resistance of the airbag
module (squib) even if you are using a specified tester. If the
circuit resistance is measured with a tester, accidental airbag
deployment will result in serious personal injury.
|
|
Components and components location

1. Passenger airbag (PAB)
|
|
Repair procedures
Never attempt to measure the circuit resistance of the airbag module
(squib) even if you are using the specified tester. If the circuit resistance
is measured with a tester, accidental airbag deployment will result in serious
personal injury.
|
1. |
Inspect the airbag according to troubleshooting table.
(Refer to Passenger Airbag Module - "Troubleshooting")
|
If the passenger airbag module has been deployed, replace the damaged
crash pad.
|
1. |
Remove the main crash pad assembly.
(Refer to Body - "Main Crash Pad Assembly")
|
2. |
Remove the passenger airbag module (A) after loosening the bolts.
Tightening torque :
3.9 - 5.8 N·m (0.4 - 0.6 kgf·m, 2.8 - 4.3 lb·ft, 34.7 - 52.0
lb·in)
|

|
1. |
Install in the reverse order of removal.
|
2. |
After installing the airbag module, confirm proper system operation:
Switch "ON" the ignition. The SRS indicator light should turn on for
about six seconds and then off.
|
Troubleshooting

Description and operation
Description
The Driver Airbag (DAB) is installed in the steering wheel and electrically connected
to SRSCM via the clock spring. It protects the driver by dep ...
Description and operation
Description
The Side Airbags (SAB) are installed inside the front seat and protects the driver
and passenger from danger when a side crash occurs. The SRSCM d ...
Other information:
Repair procedures
Oil And Filter Replacement
•
Prolonged and repeated contact with mineral oil will result in
the removal of natural fats from the skin, leading to dryness, irritation
...
Schematic diagrams
Connector and Terminal Function
Repair procedures
Inspection
1.
Disconnect the negative battery terminal.
2.
Remove the rear pillar trim [LH].
(Refer to Body - "Rear Pillar Trim")
...