Kia Optima DL3: Hydraulic System / Valve Body
Repair procedures
| Replacement |
It is not recommended to replace the valve body . If the valve body needs to be replaced, the automatic transaxle assembly should be replaced and the oil pressure characteristics should be input using the KDS. If replacing the valve body, it is not possible to input the oil pressure characteristics using the KDS and if not performing the oil pressure characteristics input procedure, a shift shock or delay may occur. |
| 1. |
Replace the automatic transaxle assembly. (Refer to Automatic Transaxle System - "Automatic Transaxle System") |
Repair procedures Inspection Automatic Transaxle Fluid (ATF) Level Check When checking the ATF level, be careful not to allow foreign substance (like dust) to enter through the filler hole.
Repair procedures Removal If ATF is leaking due to damage on O-ring, replace O-ring with a new one.
Other information:
Kia Optima DL3 2019-2026 Service and Repair Manual: Vanity Lamp
Repair procedures Removal When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. 1.
Kia Optima DL3 2019-2026 Service and Repair Manual: Heater Unit
Components and components location Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Temperature control actuator [LH] 3. PTC Heater dummy 4.
Categories
- Manuals Home
- Kia Optima Owners Manual
- Kia Optima Service Manual
- Floor Console Assembly
- Motor Driven Power Steering
- Heating, Ventilation and Air Conditioning
- New on site
- Most important about car
