Kia Optima DL3: Heating, Ventilation and Air Conditioning / Controller
Components and components location Components Location 1. Intake actuator Description and operation Description The intake actuator is located at the blower unit.
Components and components location Components Connector Pin Function [Connector A] Pin NO Funtion Pin NO Funtion 1 Battery (+) 21 IGN2 2 ILL+ (TAIL) 22 IGN1 3 Sensor REF (+5V) 23 - 4 Mode Control Actuator Feedback 24 - 5 Temperature Actuator Feedback 25 - 6 Intake Actuator Feedback 26 - 7 EVAP Sensor (+) 27 - 8 AMB Sensor (+) 28 - 9 - 29 CAN High 10 Max Blower signal 30 CAN Low 11 Blower on signal 31 - 12 Temperature Control Actuator (Warm) 32 HTD (Rear Defrost) 13 Temperature Control Actuator (Cool) 33 P_CAN High 14 Intake Actuator (Recirculated Air) 34 P_CAN Low 15 Intake Actuator (Fresh Air) 35 - 16 Mode Control Actuator (Defrost) 36 - 17 Mode Control Actuator (Vent) 37 - 18 Sensor Ground 38 ECV+ 19 ILL - (RHEO) 39 ECV- (Ground) 20 Ground 40 Ground [Connector B] Pin NO Funtion Pin NO Funtion 1 Low 4 Middle Low 2 Common 5 Middle High 3 Ground 6 High Repair procedures Replacement 1.
Other information:
Kia Optima DL3 2019-2026 Service and Repair Manual: Rear Glass Defogger Printed Heater
Repair procedures Inspection • Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply pressure on the tin foil with hand and move the tin foil along the grid line to check for open circ
Kia Optima DL3 2019-2026 Service and Repair Manual: A/C Pressure Transducer
Description and operation Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed.
Categories
- Manuals Home
- Kia Optima Owners Manual
- Kia Optima Service Manual
- Identification Numbers
- Heating, Ventilation and Air Conditioning
- Body (Interior and Exterior)
- New on site
- Most important about car
