Kia Optima DL3: Cooling System / Reservoir Tank

Kia Optima DL3 2019-2026 Service and Repair Manual / Engine Mechanical System / Cooling System / Reservoir Tank

Repair procedures

Removal and Installation
1.

Remove the reservoir tank.

(1)

Disconnect the degassing hose (A).

(2)

Disconnect the reservoir tank water hose (B).

(3)

Remove the reservoir tank (C).

Tightening torque :

7.8 - 11.7 N•m (0.8 - 1.2 kgf•m, 5.7 - 8.6 lb•ft)

2.

Install in the reverse order of removal.

    Repair procedures Refilling And Bleeding    Never remove the reservoir tank cap when the engine is hot.

    Components and components location Components 1. Cooling fan 2. Cooling fan motor 3. Cooling fan shroud Specifications Specifications Item Specification Fan type PULLER Fan speed control Resisor Air flow rate (㎥/h) 1,950 - 8% min.

    Other information:

    Kia Optima DL3 2019-2026 Service and Repair Manual: High Mounted Stop Lamp

    Repair procedures Removal 1. Disconnect the negative battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3. Disconnect the high mounted stop lamp connector (A).

    Kia Optima DL3 2019-2026 Service and Repair Manual: Mode Control Actuator

    Components and components location Components Location 1. Mode control actuator Description and operation Description The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C co

    Categories

     
    Copyright © 2026 www.kioptima.com - 0.0218