Kia Optima: Installing a Child Restraint System (CRS) / Securing a child restraint with the LATCH anchors system

Kia Optima DL3 2019-2020 Owner's Manual / Safety features of your vehicle / Child Restraint System (CRS) / Installing a Child Restraint System (CRS) / Securing a child restraint with the LATCH anchors system

To install a LATCH-compatible child restraint in either of the rear outboard seating positions: 1. Move the seat belt buckle away from the lower anchors.

2. Move any other objects away from the anchors that could prevent a secure connection between the child restraint and the lower anchors.

3. Place the child restraint on the vehicle seat, then attach the seat to the lower anchors according to the instructions provided by the child restraint manufacturer.

4. Follow the child restraint instructions for properly adjusting and tightening the lower attachments on the child restraint to the lower anchors.

WARNING

Take the following precautions when using the LATCH system:

Lower Anchors and Tether for Children (LATCH) System
The LATCH system holds a child restraint during driving and in an accident. This system is designed to make installation of the child restraint easier and reduce the possibility of improperly inst ...

Securing a child restraint seat with "Tether Anchor" system
First secure the child restraint with the LATCH lower anchors or the seat belt. If the child restraint manufacturer recommends that the top tether strap be attached, attach and tighten the top t ...

Other information:

Kia Optima DL3 2019-2020 Service and Repair Manual: Exhaust Emission Control System


Description and operation Description Exhaust emissions (CO, HC, NOx) are controlled by a combination of engine modifications and the addition of special control components. Modifications to the combustion chamber, intake manifold, camshaft and ignition system form the basic cont ...

Kia Optima DL3 2019-2020 Owner's Manual: Windshield wipers


Operates as follows when the ignition switch is turned ON. MIST : For a single wiping cycle, move the lever to this (MIST) position and release it. The wipers will operate continuously if the lever is held in this position. OFF : Wiper is not in operation INT : Wiper operates intermittently at ...

Copyright © www.kioptima.com 2017-2020