Kia Optima DL3: Body (Interior and Exterior) / Trunk Lid
Repair procedures
| Adjustment |
| 1. |
Place the car on a flat surface and check whether the body and trunk lid are well-aligned. |
| 2. |
After loosening the trunk lid hinge (A) mounting bolt, adjust the trunk lid by moving it up and down or from side to side. |
| 3. |
Adjust the gap between the trunk lid and body by turning the trunk lid overslam bumpers (B). |
| 4. |
After loosening the trunk lid striker (C) mounting bolts, adjust the striker by moving it back and forth or from side to side and then tighten the mounting bolts. |
| 5. |
Make sure the trunk lid opens or closes properly.
|
Components and components location Component Location 1. Hood latch assembly Repair procedures Replacement 1.
Components and components location Component Location 1. Trunk lid assembly Repair procedures Replacement Wear gloves to protect hands from injury.
Other information:
Kia Optima DL3 2019-2026 Service and Repair Manual: In-car Sensor
Description and operation Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater co
Kia Optima DL3 2019-2026 Service and Repair Manual: Blower Resistor
Repair procedures Inspection 1. Measure the resistance between the terminals. 2. measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) (1) Pin No 1.
Categories
- Manuals Home
- Kia Optima Owners Manual
- Kia Optima Service Manual
- Automatic Transaxle System
- Battery
- Headlamps
- New on site
- Most important about car
