Kia Optima DL3: Indicator Lights / Immobilizer Indicator Light (With Smart Key)

Kia Optima DL3 2019-2025 Owner's Manual / Features of your vehicle / Indicator Lights / Immobilizer Indicator Light (With Smart Key)

This indicator light illuminates for up to 30 seconds:

• When the vehicle detects the appropriate smart key with immobilizer in your vehicle while the Engine Start/Stop Button is ACC or ON.

- At this time, you can start the engine.
- The indicator light goes off after starting the engine.

This indicator light blinks for a few seconds:

• When the smart key is not in the vehicle.

- At this time, you can not start the engine.

This indicator light illuminates for 2 seconds and goes off:

• When the vehicle can not detect the smart key which is in the vehicle while the Engine Start/Stop Button is ON.

In this case, have your vehicle inspected by an authorized Kia dealer.

This indicator light blinks:

  • When the battery of the smart key is weak.
    - At this time, you can not start the engine. However, you can start the engine if you press the Engine Start/Stop Button with the smart key. (For more details, refer to “Starting the Engine” in chapter 5).
  • When there is a malfunction with the immobilizer system.

In this case, have your vehicle inspected by an authorized Kia dealer.

    Electronic Stability Control (ESC) OFF Indicator Light This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position.

    Turn Signal Indicator Light This indicator light blinks: • When you turn the turn signal light on. If any of the following occurs, there may be a malfunction with the turn signal system.

    Other information:

    Kia Optima DL3 2019-2025 Service and Repair Manual: Power Seat Control Switch

    Repair procedures Removal 1. Remove the front seat shield outer cover. (Refer to Body - "Front Seat Shield Outer Cover") 2. Remove the power seat control switch (A) by loosening the mounting screws.

    Kia Optima DL3 2019-2025 Service and Repair Manual: Blower Resistor

    Repair procedures Inspection 1. Measure the resistance between the terminals. 2. measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) (1) Pin No 1.

    Categories

     
    Copyright © 2025 www.kioptima.com - 0.0208